Analisis Perancangan Jaringan Fiber to The Home Area Universitas Nasional Blok IV dengan Optisystem

Authors

  • Efan Nuari Universitas Nasional, Jakarta
  • Iskandar Fitri Universitas Nasional, Jakarta
  • Nurhayati Nurhayati Universitas Nasional, Jakarta

DOI:

https://doi.org/10.30865/mib.v4i2.1984

Keywords:

FTTH, Bit Error Rate, Link Power Budget, Rise Time Budget, Q – Factor

Abstract

Researchers will be designing the access network Fiber To The Home (FTTH) on the technology of Gigabit Passive Optical Network (GPON). The location that became the case study was the National University of Block IV, where the network speed at the site was slightly reduced speed. The purpose is to get the design of an access service network that is expected to be implemented for triple play services. Starting with data collection of data. The Fiber To The Home (FTTH) network design determining device specification, layout and number of devices used and simulated using Optisystem application. Then in the analysis based on predefined parameters in the form of BER (Bit Error Rate), Link Power Budget, and Rise Time Budget that meet the optical network with the standard of PT. Telkom. The results of the BER value has fulfilled the minimum BER value specified for fiber optic is 10-9 and for parameter Q – Factor obtained value 9,32288 so that has been meets the standard because it shows values above 6

Author Biographies

Efan Nuari, Universitas Nasional, Jakarta

Fakultas Teknologi Komunikasi Informasi, Informatika

Iskandar Fitri, Universitas Nasional, Jakarta

Fakultas Teknologi Komunikasi Informasi, Informatika

Nurhayati Nurhayati, Universitas Nasional, Jakarta

Fakultas Teknologi Komunikasi Informasi, Informatika

References

I. Gita, Sugito, and A. R. Bermano, “Perancangan Jaringan Akses Fiber To The Home (FTTH) Dengan Teknologi Gigabit Passive Optical Network (GPON) Di Private Village, Cikenong,†e-Proceeding Eng., vol. 2, no. 3, pp. 7116–7124, 2015.

R. M. Muttaqien et al., “Perancangan jaringan akses fiber to the home (ftth) menggunakan teknologi 10 - gigabit passive optical network (xgpon) untuk perumahan graha yasa asri dengan ducting bersama,†e-Proceeding Eng. Univ. Telkom, vol. 3, no. 2, pp. 1584–1594, 2016.

L. D. Sarie, “Perancangan Dan Analisis Jaringan Fiber To the Home ( Ftth ) Untuk Perumahan Pesona Ciwastra Vill ....,†no. December, pp. 0–7, 2015.

O. Pada, L. Sto, A. Yani, and K. E. Apartemen, “[2] [3],†vol. 1, no. 1, pp. 97–103, 2014.

F. Rosanto et al., “Analisis Perancangan Jaringan Fiber To The Home Area Jakarta Garden City ( Jakarta Timur ) dengan Metode Link Power Budget dan Rise Time Budget,†pp. 15–17, 2017.

D. Optisystem and P. Link, “Analisis Pengujian Implementasi Perangkat Fiber To the Home ( Ftth ),†no. December, 2015.

M. I. Mutaharrik, “Perancangan Jaringan Fiber To the Home ( FTTH ) Menggunakan Teknologi Gigabit Passive Optical network (GPON) Di Central Karawaci,†e-Proceeding Eng., vol. 3, no. 1, pp. 576–583, 2016.

B. Dermawan, I. Santoso, and T. Prakoso, “Analisis Jaringan Ftth (Fiber To the Home) Berteknologi Gpon (Gigabit Passive Optical Network),†vol. 18, no. 1, pp. 30–37, 2016.

Y. I. Putri, “Pengukuran Fiber To the Home (Ftth) Di Perumahan Pesona Ciganitri Dengan Menggunakan Optisystem,†p. 8, 2015.

A. Barus, Hafidudin, and T. N. Damayanti, “Perancangan Jaringan Fiber To the Home(Ftth) Menggunakan Gigabite Passive Optical Network(Gpon) Di Perumahan Cluster Courtyard Karawang,†e-Proceeding Appl. Sci., vol. 15, no. 4, pp. 127–138, 2017.

R. F. Adiati, A. Kusumawardhani, and H. Setijono, “Analisis Parameter Signal to Noise Ratio dan Bit Error Rate dalam Backbone Komunikasi Fiber Optik Segmen Lamongan-Kebalen,†J. Tek. ITS, vol. 6, no. 2, pp. 8–12, 2017.

K. D. Pramaditya, “Pembuatan Desain Jaringan Fiber To the Home ( Ftth ) Pada,†Univ. Telkom, vol. 1, no. December, 2015.

L. Purnamasari, “Perancangan Dan Analisis Jaringan Fiber To the Home ( Ftth ) Dengan Optisystem Untuk Perumahan ...,†no. December, 2015.

Downloads

Published

2020-04-25

Issue

Section

Articles