Hidroponik Pintar Menggunakan Fuzzy Logic Berbasis Internet of Things Pada Tanaman Selada

Authors

  • Aris Martin Kobar Universitas Buana Perjuangan Karawang, Karawang
  • Jamaludin Indra Universitas Buana Perjuangan Karawang, Karawang
  • Yana Cahyana Universitas Buana Perjuangan Karawang, Karawang

DOI:

https://doi.org/10.30865/mib.v7i4.6731

Keywords:

Hydroponics, Fuzzy Logic, Internet of Things, Lettuce

Abstract

Changes in land use have become one of the drivers of innovation in modern agriculture, so research and development has been carried out on hydroponic systems. Hydroponic systems require special treatment on several parameters for optimal results and good quality. Manual verification is considered less effective because agents have to do it more often, so there are often delays in monitoring and adding nutrient solutions to the water. Previous researchers have controlled hydroponic systems using various methods. To regulate the nutrition of the hydroponic system in the hydroponic management system using Fuzzy Logic Control based on Electrical Conductivity (EC) used in the fuzzy input is the EC error and determining the duration of turning on the nutrient valve which shows the results that the fuzzy logic control can maintain the EC value range according to plant needs with water depth. In this research, monitoring and managing nutrition, temperature and water level in a hydroponic system is designed using Fuzzy Logic based on the Internet of Things so that monitoring and setting Parts Per Million (PPM) can be done automatically so that you can monitor lettuce plants remotely according to their age. can be viewed via the web application. The test results in this research obtained that the accuracy of the TDS sensor in detecting water TDS values was 97.78%, and the accuracy of the DS18B20 sensor in detecting water temperature conditions was 98.37%. The fuzzy test obtained an error value of 10%.

References

R. Prabowo, aziz nur Bambang, and Sudarno, “Pertumbuhan Penduduk Dan Alih Fungsi Lahan Pertanian,†J. Ilmu-Ilmu Pertan., vol. 16, no. 2, pp. 26–36, 2020.

P. W. Ciptadi and R. H. Hardyanto, “Penerapan Teknologi IoT pada Tanaman Hidroponik menggunakan Arduino dan Blynk Android,†J. Din. Inform., vol. 7, no. 2, pp. 29–40, 2018.

F. Suryatini, S. Pancono, S. B. Bhaskoro, and P. M. S. Muljono, “Sistem Kendali Nutrisi Hidroponik berbasis Fuzzy Logic berdasarkan Objek Tanam,†ELKOMIKA J. Tek. Energi Elektr. Tek. Telekomun. Tek. Elektron., vol. 9, no. 2, p. 263, 2021, doi: 10.26760/elkomika.v9i2.263.

C. Maucieri, C. Nicoletto, R. Junge, Z. Schmautz, P. Sambo, and M. Borin, “Hydroponic systems and water management in aquaponics: A review,†Ital. J. Agron., vol. 13, no. 1, pp. 1–11, 2018, doi: 10.4081/ija.2017.1012.

J. N. D. Tiljuir, M. A. A. Gafur, and F. Rosalina, “Pengaruh Perbedaan Dosis Nutrisi AB Mix Sistem Hidroponik Rakit Apung Terhadap Pertumbuhan Tanaman Selada (Lactuca Sativa L.),†Agriva J. (Journal Agric. Sylva), vol. 1, no. 1, pp. 19–26, 2022.

I. Puspasari, Y. Triwidyastuti, and H. Harianto, “Otomasi Sistem Hidroponik Wick Terintegrasi pada Pembibitan Tomat Ceri,†J. Nas. Tek. Elektro dan Teknol. Inf., vol. 7, no. 1, 2018, doi: 10.22146/jnteti.v7i1.406.

A. E. Pakzad and A. A. Pakzad, “Fuzzy Ponics: a Fuzzy Based System to Control Temperature, Relative Humidity, Electrical Conductivity and PH of Hydroponics,†Int. J. Eng. Technol., pp. 308–312, 2018.

G. G. Heliadi, M. R. Kirom, and A. Suhendi, “Monitoring and Control of Nutrition on NFT Hydroponic System Based on Electrical Conductivity,†e-Proceeding Eng., vol. 5, no. 1, pp. 885–893, 2018.

Y. Triwidyastuti, I. Puspasari, and H. Harianto, “Comparison between PID and Fuzzy Controller to Hydroponic Temperature,†ICITAS Int. Conf. Inf. Technol. Appl. Syst., pp. 21–27, 2018.

A. R. Al Tahtawi and R. Kurniawan, “PH control for deep flow technique hydroponic IoT systems based on fuzzy logic controller,†J. Teknol. dan Sist. Komput., vol. 8, no. 4, pp. 323–329, 2020, doi: 10.14710/jtsiskom.2020.13822.

Y. Setiawan, H. Tanudjaja, and S. Octaviani, “Penggunaan Internet of Things (IoT) untuk Pemantauan dan Pengendalian Sistem Hidroponik,†TESLA J. Tek. Elektro, vol. 20, no. 2, p. 175, 2019, doi: 10.24912/tesla.v20i2.2994.

R. B. Lukito and C. Lukito, “Development of IoT at hydroponic system using raspberry Pi,†Telkomnika (Telecommunication Comput. Electron. Control., vol. 17, no. 2, pp. 897–906, 2019, doi: 10.12928/TELKOMNIKA.V17I2.9265.

R. F. Zahra, S. P. Sakti, and D. Anggraeni, “Rancang Bangun Pengontrol Jarak Menggunakan Motor Stepper Nema 17 Berbasis Mega 2560 Pro pada Ultrasonic Atomizer Spray Coating,†J. Fis. Univ. Brawijaya, vol. 6 no. 3, August, 2021.

V. R. Suryawanshi, H. C. Surani, and H. R. Yadav, “Sensor-based automatic hand sanitizer dispenser,†Med. J. Dr. D.Y. Patil Vidyapeeth, vol. 14, no. 5, pp. 543–546, 2021, doi: 10.4103/mjdrdypu.mjdrdypu_221_20.

P. Studi, T. Informatika, and S. Adhi, “Irigation Monitoring Control Untuk Tanaman Hidroponik Dengan Metode Nft Menggunakan Arduino Berbasis SMS,†vol. 9, no. 1, pp. 77–85, 2020.

R. N. Fauzi, Y. Suprapto, and R. D. Puspita, “PROSIDING RANCANGAN PROTOTIPE DE-ICING DENGAN MENGGUNAKAN,†pp. 1–6, 2019.

F. Puspasari et al., “Sensor Ultrasonik HCSR04 Berbasis Arduino Due untuk Sistem Monitoring Ketinggian,†pp. 2–5, 2019.

T. F. Siallagan, “Rancang Bangun Sistem Keamanan Terhadap Kunci Ruangan Berbasis Bot Telegram Menggunakan Mikrokontroler Esp8266,†vol. 02, no. 02, pp. 45–54, 2020.

D. R. Wati and W. Sholihah, “Pengontrol pH dan Nutrisi Tanaman Selada pada Hidroponik Sistem NFT Berbasis Arduino,†Multinetics, vol. 7, no. 1, pp. 12–20, 2021, doi: 10.32722/multinetics.v7i1.3504.

M. D. D. Wiguna, “Pengembangan Media Pembelajaran Trainer Pengendali Elektromagnetik Berbasis Smart Relay,†vol. 9, no. 3, pp. 203–212, 2020, [Online]. Available: https://repo.undiksha.ac.id/1169/%0Ahttps://repo.undiksha.ac.id/1169/3/1615061009-BAB I PENDAHULUAN.pdf

S. Hardi, “Rancang bangun sistem pengepresan kaleng minuman otomatis menggunakan aktuator pneumatik berbasis arduino uno 1,2,3,†vol. 3, no. 1, pp. 64–69, 2019.

Y. R. Pratiwi, Febriansyah, and H. S. Putra, “Pemanfaatan Efek Seebeck Pada Peltier Sebagai Generator Darurat Dengan dan Tanpa Step Up DC to DC,†J. Sci. Nusant., vol. 1, no. 2, p. 31, 2021.

J. Winanjar and D. Susanti, “Rancangan Bangunan Sistem Informasi Administrasi desa Berbasis web menggunakan PHP dan MySQL,†Pros. Semin. Nas. Apl. Sains Teknol., pp. 97–105, 2021.

R. F. Hanung Pangestu Rahman, Jamaludin Indra, “Penerapan Convolutional Neural Network pada Timbangan Pintar Menggunakan ESP32-CAM,†J. Media Inform. Budidarma, vol. 7, no. 2614-5278 (media cetak), ISSN 2548-8368 (media online), pp. 1–9, 2023, doi: 10.30865/mib.v7i1.5469.

D. Maulana, J. Indra, and ..., “Pengembangan Sistem Kumbung Jamur Dengan Nodemcu Esp8266 Menggunakan Metode Fuzzy Logic,†… Student J. …, vol. III, pp. 235–245, 2022.

M. W. Hamdani, A. Stefanie, Y. Saragih, and U. S. Karawang, “Perancangan dan Implementasi Metode Kontrol Fuzzy Logic Mamdani pada Sistem Kontrol TDS dan pH Hidroponik,†J. Teknol. Terpadu, vol. 10, no. 2, pp. 171–183, 2022.

A. Apriansyah, A. Fauzi, and S. Faisal, “Penerapan Fuzzy Logic Untuk Menentukan Indeks Massa Tubuh ( IMT ) Berbasis Internet of Things ( IoT ),†J. Media Inform. Budidarma, vol. 7, no. 1, pp. 292–299, 2023, doi: 10.30865/mib.v7i1.5470.

Downloads

Published

2023-10-24

Issue

Vol. 7 No. 4 (2023): Oktober 2023

Section

Articles

License

Creative Commons License
This work is licensed under a Creative Commons Attribution 4.0 International License

Authors who publish with this journal agree to the following terms:

  1. Authors retain copyright and grant the journal right of first publication with the work simultaneously licensed under Creative Commons Attribution 4.0 International License that allows others to share the work with an acknowledgment of the work's authorship and initial publication in this journal.
  2. Authors are able to enter into separate, additional contractual arrangements for the non-exclusive distribution of the journal's published version of the work (e.g., post it to an institutional repository or publish it in a book), with an acknowledgment of its initial publication in this journal.
  3. Authors are permitted and encouraged to post their work online (e.g., in institutional repositories or on their website) prior to and during the submission process, as it can lead to productive exchanges, as well as earlier and greater citation of published work (Refer to The Effect of Open Access).